MACHINE OPERATOR (4)
Monday - Friday
6:00 am - until job is completed
$18.76 per hour
ESSENTIAL JOB FUNCTIONS
- Remove all debris and foreign material from mold.
- Appropriately apply a thin layer of oil to coat mold skin from top to bottom of the mold
- Articulate the difference in chuck bodies and wedges and install them correctly on to the mold strand.
- Read and, measure and install the false plate per the engineered drawing
- Read and comprehend the daily layout sheet and install the correct size spiral wire in the mold to approximately match the mold sections dimensions.
- Read and comprehend the engineered drawing and determine the correct type and length of demold and install correctly and while it is flush and secured in place at the tip of the tension plate with tie wire.
- Obtains initial stress jack certification from EHS.
- Install the correct size spiral wire in the mold to approximately match the mold sections dimensions
- Identify and report safety hazards
- Assist with general plant clean up and housekeeping
- Perform safety audits
- Participate in Lean manufacturing, Gemba and 5S
JOB REQUIREMENTS
- One to two years of relevant experience
- Pay attention to detail and follow work instructions
- High awareness for safety with the ability to wear all required PPE and work in a non-temperature controlled environment, as well as with exposure to outdoors
- Ability to safely lift up to 50 pounds, although most frequent lift is up to 30 pounds
- Ability to be company trained and authorized to operate equipment and machinery
- Knowledge of production equipment\hand held tools used in department in a professional manner
- Ability to read blue prints
- Be able to read the daily layout sheet and install the correct size spiral wire in the mold to approximately match the mold sections dimensions
- Ability to accurately use and read a tape measure
Highly Qualified Candidates Will Also Possess These Qualifications
- High School diploma or GED
- Machine and equipment certification
